Administrator Guide

Example
DellEMC(conf)# interface range tengigabitethernet 1/1 - 2
DellEMC(conf-if-range-gi-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
DellEMC(conf-if-range-gi-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface-type[—range]
Parameters
interface Enter one of the following keywords and the interface information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For stack-units, enter the keywords stack-unit then the slot/port information.
• For a Null interface, enter the keyword null then the Null interface number.
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
NOTE: This command also enables you to view information corresponding to
a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is different from how you
specify in non-ON platforms.
-range (Optional) Enter the range of interfaces for which you want to view the information. The
format is interface-type slot/port/[subport]-slot/port/[subport]
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.3) Included the FEC types in the output for 25G, 50G, and 100G interfaces of the Z9100–
ON.
9.14(0.0) Included the FEC counter details in the output for 25 and 50G interfaces of the S5048–
ON.
9.12(1.0) Introduced on the S5048F–ON.
9.12(0.0) Added the OUI value in the command output for the Z9100–ON.
9.11(0.0)
Included the FEC BER details in the output for 100G interfaces of S6100–ON and Z9100–
ON.
698 Interfaces