Administrator Guide

Version Description
9.14(1.0) Introduced arp-inspection option.
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON, S3048–
ON, S6000, S6010–ON, S5048F-ON, FN-IOM and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage Information
This command has to be configured before the interface moves to Err-disabled state. If not, the recovery action is
not performed.
Related
Commands
errdisable recovery interval— Configure recovery timer interval for an interface.
errdisable recovery interval
Configure recovery time interval to move an interface from the Err-disabled state.
Syntax
errdisable recovery interval seconds
To remove the configured recovery time interval, use the no errdisable recovery interval seconds
command.
Parameters
interval seconds Enter the keyword interval and the number of seconds to recover the interface from
Err-disabled state. The range is from 30 to 86,400 seconds. The default is 300 seconds.
Defaults 300 seconds.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON, S3048–
ON, S6000, S6010–ON, S5048F-ON, FN-IOM, and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage Information
Whenever the Err-disable recovery timer is reconfigured, it will get effective only after the current timer expires.
Following message is displayed after each Err-disable recovery timer configuration:
DellEMC(conf)# errdisable recovery interval 30
New timer interval will be effective from the next timer instance only.
Related
Commands
errdisable recovery cause — Enable automatic recovery of an interface from the error disabled state.
flowcontrol
Control how the system responds to and generates 802.3x pause flow control frames.
Syntax
flowcontrol {rx {off | on} tx {off | on} [negotiate | pause-threshold value |
resume-offset value] | [monitor session-ID]}
To return to the default, use the no form of this command.
Parameters
rx on Enter the keywords rx on to process the received flow control frames on this port.
NOTE: Flow-control packets are mirrored only when flow-control rx is
enabled on an interface.
Interfaces 671