Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048T-ON

471

472

473

474

475

476

477

478

479

480

Defaults None

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6100-ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON and Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

By default, iSCSI is enabled on the unit and the flow control is enabled on all of the interfaces. It is also acts as

defaults when the link-level flow control is enabled on one or more interfaces.

Enables priority flow control or enhance transmission selection on interface.

Commands

• dcb <ets | pfc> enable — enable priority flow control or enhanced transmission selection on interface.

PFC Commands

The following PFC commands are supported on the Dell EMC Networking OS.

clear pfc counters

Clear the PFC TLV counters and PFC statistics on an interface or stack unit.

Syntax

clear pfc counters [interface-type | stack-unit {unit number | all } all stack-

ports all}]

Parameters

interface

interface-type

Enter the keywords port-type then the interface information.

stack-unit

unit

number

Enter the keywords stack-unit then the stack-unit number to be cleared.

statistics Enter the keyboard statistics to clear the hardware PFC counters.

stack-ports all Enter the keywords stack-ports all to clear the counters on all stack ports.

Defaults none

Command Modes EXEC Privilege