Administrator Guide

• The seq sequence-number command is applicable only in an ACL group.
• The order option works across ACL groups that are applied on an interface via the QoS policy framework.
• The order option takes precedence over seq sequence-number.
• If you do not configure sequence-number, the rules with the same order value are ordered according to
their configuration order.
• If you configure sequence-number, the sequence-number is used as a tie breaker for rules with the same
order.
When you use the log option, the CP processor logs details about the packets that match. Depending on how
many packets match the log entry and at what rate, the CP may become busy as it has to log these packets’
details.
If you configure the sequence-number, the sequence-number is used as a tie breaker for rules with the
same order.
NOTE: When you configure ACL logging and byte counters simultaneously, byte counters may
display an incorrect value. Configure packet counters with logging instead.
Related
Commands
• deny — configure a filter to drop packets.
• permit — configure a filter to forward packets.
Common MAC Access List Commands
The following commands are available within both MAC ACL modes (Standard and Extended) and do not have mode-specific options.
These commands allow you to clear, display, and assign MAC ACL configurations.
The platform supports both Ingress and Egress MAC ACLs.
The MAC ACL can be applied on Physical, Port-channel and VLAN interfaces. As per the specified rules in the ACL, the traffic on the
interface/ VLAN members or Port-channel members will be permitted or denied.
clear counters mac access-group
Clear counters for all or a specific MAC ACL.
Syntax
clear counters mac access-group [mac-list-name]
Parameters
mac-list-name (OPTIONAL) Enter the name of a configured MAC access list.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
220 Access Control Lists (ACL)