Administrator Guide

Slot/Port information need not contain a space before and after the dash. For example,
both of the following commands are valid: interface group
tengigabitethernet 1/1 - 1/5; interface group
tengigabitethernet 1/1-1/5.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port
/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL Switch.
Usage Information
The interface group command will create all the non-existent VLANs specified in the range. On successful
command execution, the CLI switches to the interface group context.
The configuration commands inside the group context will be the similar to that of the existing range command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and physical interfaces.
Example
DellEMC(conf)# interface group ?
fortyGigE FortyGigabit Ethernet interface
gigabitethernet GigabitEthernet interface IEEE 802.3z
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN keyword
DellEMC(conf)# interface group vlan 1 - 2 , tengigabitethernet 1/10
DellEMC(conf-if-group-vl-1-2,te-1/10)# no shutdown
DellEMC(conf-if-group-vl-1-2,te-1/10)# end
Related
Commands
• interface range — configure a range of interfaces.
• interface vlan — configures a VLAN.
interface loopback
Configure a Loopback interface.
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
number Enter a number as the interface number. The range is from 0 to 16383.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Interfaces 675