Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the support for interfaces.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or switchport. To
place an interface in Layer 2 mode, ensure that the interface’s configuration does not contain an IP address and
enter the switchport command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default configuration.
To delete a tunnel interface, use the no interface tunnel tunnel-id command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the next hop to the tunnel
destination is over a physical interface. If you select any other interface as the next hop to the tunnel destination,
the tunnel interface does not operate as an ECMP.
Example
DellEMC(conf)# int tengigabitethernet 1/10
DellEMC(conf-if-te-1/10)# exit
DellEMC(conf)#
Related
Commands
• interface loopback — configure a Loopback interface.
• interface null — configure a Null interface.
• interface port-channel — configure a port channel.
• interface vlan — configure a VLAN.
interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set of configurations on a group of
interfaces.
Syntax
interface group [interface | vlan vlanid {- vlanid } ]
To delete a range of VLANs, use the following command:
no interface group vlan vlanid {- vlanid}
Parameters
interface,
interface,...
Enter the keywords interface group and one of the interfaces — slot/port or VLAN
number. Select the range of interfaces for bulk configuration. Spaces are not required
between the commas. Comma-separated ranges can include VLANs and physical
interfaces.
Enter the member VLANs using VLAN IDs (separated by commas), a range of VLAN IDs
(separated by a hyphen), a single VLAN ID, or a combination. For example: VLAN IDs
(comma-separated): 3, 4, 6. Range (hyphen-separated): 5-10.
674 Interfaces