Administrator Guide

service-class buffer shared-threshold-weight
Create a service class and associate the threshold weight of the shared buffer with each of the queues per port in the egress direction.
Syntax
[No] Service-class buffer shared-threshold-weight {[queue0 number] || [queue1
number] || [queue2 number] || [queue3 number] || [queue4 number] || [queue5
number] || [queue6 number] || [queue7 number]}
Parameters
buffer Define the shared buffer settings
shared-threshold-
weight
Specify the weight of a queue for the shared buffer space
queue 0 to queue 7 To apply the shared-threshold weight, specify the queue number
number Enter a weight for the queue on the shared buffer as a number in the range of 1 to 11.
Default The default threshold weight on the shared buffer for each queue is 9. Therefore, each queue can consume up to
66.67 percent of available shared buffer by default.
Command Modes INTERFACE mode
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.9(0.0) Introduced on the Z9500, S4810, S4820T, S5000, and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S6000.
Usage Information
You can configure all the data queues. You can configure queues 0-7.
The following table describes the mapping between the threshold weight of the shared buffer on the queue. It
also shows the percentage of the available shared buffer used by the queues for each of the corresponding
threshold weights of the shared buffer:
shared-
threshold-
weight on the
queue
% of available shared buffer that can be consumed by the queue
0 No dynamic sharing; shared buffer = 0.
1 0.77%
2 1.54%
3 3.03%
4 5.88%
5 11.11%
6 20%
7 33.33%
8 50%
9 66.67%
10 80%
11 88.89%
514 Data Center Bridging (DCB)