Administrator Guide

host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
udf-pkt-format
name
Enter the keywords udf-pkt-format then the UDF ACL profile name.
udf-qualifier-value
name
Enter the keywords udf-qualifier-value then the UDF qualifier value profile name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip udf-qualifier-
value ipnip_val1
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — creates an extended ACL.
show config
Display the current UDF TCAM profile configuration.
Syntax
show config
Command Modes CONFIGURATION-UDF TCAM
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Example
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
key innerL3header udf-id 6 packetbase innerL3Header offset 0 length 2
match l2ethertype ipv4 ipprotocol 4 vlantag any
!
udf-qualifier-value ipnip_val1
Dell(conf-udf-tcam)#
udf-id
Assign value for each configured UDF ID in the given UDF TCAM profile.
Syntax
udf-id id value mask
Access Control Lists (ACL) 269