Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048T-ON

1651

NOTE:

• This command is only applicable for static VXLAN and does not work for the other modes of

VXLAN (controller and nuage).

• The remote VTEP should already be configured.

• In case of static VXLAN VLT deployments, this configuration should be symmetric across VLT

nodes.

feature vxlan

Enable VXLAN configuration globally on the platform.

Syntax

feature vxlan

To disable the VXLAN, use the no feature vxlan command.

Defaults Disabled

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6100–ON.

9.10(0.1P10)) Introduced on the Z9100–ON.

9.8(0.0) Introduced on the S4048–ON.

9.7(0.0) Introduced on the S6000-ON.

9.4.(0.0) Introduced on the S6000.

Usage Information You must configure feature VXLAN to configure VXLAN-instance.

Commands

vxlan-instance — Enable VXLAN Instance configuration on the platform.

fail-mode

Configures failure-mode on the platform.

Syntax

fail-mode secure

To disable the fail-mode secure, use the no fail-mode securecommand.

Parameters

secure Enter the keyword secure to delete all its database and hardware flows/resources,

when the VTEP loses connectivity with the controller.

Defaults non secure

Command Modes VXLAN INSTANCE