Administrator Guide

Example
DellEMC# show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Te 1/13
M Te 1/1-3
3 Active M Po1(Te 1/14-15)
M Te 1/18
M Te 1/4
4 Active M Po1(Te 1/14-15)
M Te 1/18
M Te 1/5
5 Active M Po1(Te 1/14-15)
M Te 1/18
M Te 1/6
DellEMC#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to an S-Tag dot1p value.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p value Enter the keyword c-tag-dot1p then the customer dot1p value that is mapped to a
service provider do1p value. The range is from 0 to 7.
sp-tag-dot1p value Enter the keyword sp-tag-dot1p then the service provider dot1p value. The range is
from 0 to 7.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
Usage Information
You can separate the C-Tag values by commas or dashed ranges. In the case of conflicts, dynamic mode CoS
overrides any Layer 2 QoS configuration.
VLAN Stacking 1611