Administrator Guide
Upstream Interfaces : Te 1/25(Dwn) Po 8(Dwn)
Downstream Interfaces : Te 1/30(Dwn)
Related
Commands
• show running-config uplink-state-group — displays the current configuration of one or more uplink-state
groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch or router.
Syntax
uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id command.
Parameters
group-id
Enter the ID number of an uplink-state group. The range is from 1 to 16.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10.0.2 Introduced on the Z9100–ON.
9.8(2.0) Introduced on the S3100 series.
9.10(0.0) Introduced on the S3148.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Usage Information
After you enter the command, to assign upstream and downstream interfaces to the group, enter Uplink-State-
Group Configuration mode.
An uplink-state group is considered operationally up if at least one upstream interface in the group is in the Link-
Up state.
An uplink-state group is considered operationally down if no upstream interfaces in the group are in the Link-Up
state. No uplink-state tracking is performed when a group is disabled or in an operationally down state.
To disable upstream-link tracking without deleting the uplink-state group, use the no enable command in
uplink-state-group configuration mode.
Example
DellEMC(conf)# uplink-state-group 16
DellEMC(conf)#
02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state group Admin
state to up: Group 16
DellEMC(conf)#
Related
Commands
• show running-config uplink-state-group — displays the current configuration of one or more uplink-state
groups.
• show uplink-state-group — displays the status information on a specified uplink-state group or all groups.
Uplink Failure Detection (UFD) 1603