Administrator Guide

key Enter a string that is the key to be exchanged between the switch and the dynamic
authorization client. The key can be up to 42 characters long.
Command Modes
• CONF-DYNAMIC-AUTH
Usage Information
• It is possible to configure more than one dynamic authorization clients Duplicate (ipv4-addr or ipv6-addr or
host-name) configurations are not allowed.
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–
ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FM-IOM, and MXL.
client-key
Configures global shared key for the trusted DAC clients.
Syntax
client—key [encryption-type] key
To remove the shared key configuration, enter the no client-key command.
Defaults None.
Parameters
encryption-type: (OPTIONAL) Enter either 0 or 7 as the encryption type for the key entered. The options
are:
• 0 — is the default and means the key is not encrypted and stored as clear text.
• 7 — means that the key is encrypted and hidden.
key Enter a string that is the key to be exchanged between the switch and RADIUS servers. It
can be up to 42 characters long.
Command Modes
• CONF-DYNAMIC-AUTH
Usage Information
• Configure global shared key applicable for DA clients. If client configuration has shared key configured, that will
take precedence.
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–
ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.
coa-bounce-port
Configure NAS to allow or reject the port bounce RADIUS messages from DAC.
Syntax
coa-bounce-port
To remove the port bounce configuration, enter the no coa-bounce-port command.
Defaults Enabled.
1364 Security