Administrator Guide

Parameters
conditional nvram-
cfg-change
(OPTIONAL) Reload into the Dell EMC Networking Operating System (OS) if the
condition is true. A configuration change to the NVRAM requires a switch reload. To
reload the switch, select nvram-cfg-change.
no-confirm
[discard-running]
Reload the chassis without prompting for further confirmation.
dell-diag (OPTIONAL) Reload the system into the Dell diagnostics mode.
onie (OPTIONAL) Reload the system into the ONIE mode. You can also use one of the
following options to reload the system and enter the respective modes directly:
• install — enter the Install mode and install the networking OS
• uninstall — enter the Uninstall mode and uninstall the networking OS
• rescue — enter the Rescue mode and access the file system
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0)
Added the optional dell-diag and onie parameters.
Introduced the no-confirm option.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell EMC Networking OS.
If there is a change in the running configuration, the system prompts you to save the new configuration when you
reload the system using the reload command. You can also save your running configuration manually using the
copy running-config command.
You can use the conditional parameter if any configuration changes made to the NVRAM, such as, stack-
group and fanout configurations, must be saved.
When you use the reload command after making configuration changes, the system prompts you to update the
hash for the startup configuration using the
verified boot hash command.
Control and Monitoring 121