Users Guide

Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF for which
you want to configure maximum number of protocol routes that
IPv4 allows.
max-number Enter the maximum number of protocol routes that a VRF RTM
can hold. The range is from 0 to 7500.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version 9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of protocol routes that the Route
Table Manager can hold for a specific VRF. This command does not apply to the
management VRFs.
Related
Commands
• show ip route — view the switch routing table.
• show ipv6 route — display the IPv6 routes.
ip mtu
Set the IP MTU (frame size) of the packet the RPM transmits for the line card interface. If the packet must be
fragmented, Dell Networking OS sets the size of the fragmented packets to the size specified in this
command.
Syntax
ip mtu value
To return to the default IP MTU value, use the no ip mtu command.
Parameters
value Enter the maximum MTU size if the IP packet is fragmented. The
range is from 576 to 9234. The default is 1500 bytes.
Defaults 1500 bytes
Command Modes INTERFACE (Gigabit Ethernet and 10-Gigabit Ethernet interfaces)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
IPv4 Routing 998