Users Guide

scp: file-url Enter the keyword scp: and specify the location of the image
file in the format userid:password@host-ip/filepath or
press Enter to launch a prompt sequence.
stack-unit stack-
unit-id
Enter the keyword stack-unit and specify the stack-unit ID to
sync the image to that stack-unit.
stack-unit all Enter the keyword stack-unit followed by the keyword all to
sync the image on all stack-units.
tftp: file-url Enter the keyword tftp: and specify the location of the image
file in the format //host-ip/filepath or press Enter to
launch a prompt sequence.
usbflash: file-url Enter the keyword usbflash: and specify the location of the
source file in the format //directory-path to upgrade form
an external flash device or press Enter to launch a prompt
sequence.
A: | B: Specify the flash partition of the operating-system image to be
upgraded.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for NFS mount.
9.2(1.0) Introduced on the Z9500.
9.0(0.0) Added support for IPv6 for the file-url parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000. Added support for the SSD on the
Z9000 only.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for TFTP and SCP.
7.6.1.0 Introduced on the S-Series.
Usage Information
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) must
be enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility this command
accepts IPv6 host addresses with or without the square brackets.
File Management 99