Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information To configure a list of possible domain names, configure the ip domain-list
command up to six times.
If you configure both the ip domain-name and ip domain-list commands, the
software tries to resolve the name using the
ip domain-name command. If the name
is not resolved, the software goes through the list of names configured with the ip
domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the
show running-config resolve command.
Related
Commands
• ip domain-name — specify a DNS server.
ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
IPv4 Routing 987