Users Guide

• ip unreachables
• load-balance
• load-balance hg
• management route
• show arp
• show arp retries
• show hosts
• show ip cam stack-unit
• show ip fib stack-unit
• show ip flow
• show ip interface
• show ip management-route
• show ipv6 management-route
• show ip protocols
• show ip route
• show ip route list
• show ip route summary
• show ip traffic
• show tcp statistics
arp
To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).
Syntax
arp [vrf vrf-name] ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
vrf vrf-name Enter a VRF name to configure an ARP entry for that VRF. Use
the VRF option after the keyword arp to configure a static arp
on that particular VRF.
ip-address Enter an IP address in dotted decimal format.
mac-address Enter a MAC address in nnnn.nnnn.nnnn format.
interface (OPTIONAL) Enter any of the following keywords and slot/port
or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
IPv4 Routing 963