Users Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(1.0) Introduced on the Z9500.
match
Apply an match filter to the crypto policy.
Syntax
match seq-num tcp [sourceip address | ipv6 address {mask} {source-
port number}] [destination ip address | ipv6 address {mask}
{destination-port number}]
To remove the match filter for the crypto map, use the no match seq-num tcp
[source ip address | ipv6 address {mask} {source-port number}]
[destination ip address | ipv6 address {mask} {destination-port
number}] command.
Parameters
seq-num Enter the match command sequence number.
sourceip-address
| ipv6 address
Enter the keyword source then the IPv4 or IPv6 address for the
source.
mask Enter the mask prefix length in /nn format.
source-port
number
Enter the source port number.
destination-port
number
Enter the destination port number.
Defaults None
Command Modes CONFIG-CRYPTO-POLICY
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Internet Protocol Security (IPSec) 956