Users Guide

A Port Channel can contain any physical interface. Based on the first interface
configured in the Port Channel and enabled, Dell Networking OS determines the
common speed. For more information, refer to channel-member.
If the line card is in a Jumbo mode chassis, you can also configure the mtu and ip mtu
commands. The Link MTU and IP MTU values configured on the channel members
must be greater than the Link MTU and IP MTU values configured on the Port Channel
interface.
NOTE: In a Jumbo-enabled system, all members of a Port Channel must be
configured with the same link MTU values and the same IP MTU values.
Example
Dell(conf)# int port-channel 2
Dell(conf-if-po-2)#
Related
Commands
• channel-member — add a physical interface to the LAG.
• interface — configure a physical interface.
• interface loopback — configure a Loopback interface.
• interface null — configure a null interface.
• interface vlan — configure a VLAN.
• shutdown — disable/enable the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG
to be also in “oper up” status.
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up”
status. The range is from 1 to 16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Interfaces 935