Users Guide

To delete a Port Channel, use the no interface port-channel channel-number
command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on S4810.
8.3.11.1 Introduced on Z9000.
8.1.1.0 Introduced on E-Series.
7.6.1.0 Introduced on S-Series.
7.5.1.0 Introduced on C-Series.
pre-Version
6.2.1.0
Introduced on E-Series.
Usage Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by
using the switchport command) or Layer 3 mode (by configuring an IP address). You
can add a Port Channel in Layer 2 mode to a VLAN.
The shutdown, description, and name commands are the only commands that you
can configure on an interface while it is a member of a Port Channel. To add a physical
interface to a Port Channel, the interface can only have the shutdown, description,
and name commands configured. The Port Channel’s configuration is applied to the
interfaces within the Port Channel.
Interfaces 934