Users Guide

Defaults Disabled — interface is in Layer 3 mode.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.4.1.0 Added support for port-channel interfaces (the port-channel
number option).
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Added the backup interface option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage Information
If an IP address or VRRP group is assigned to the interface, you cannot use the
switchport command on the interface. To use the switchport command on an
interface, only the no ip address and no shutdown statements must be listed in
the
show config output.
When you enter the switchport command, the interface is automatically added to
the default VLAN.
To use the switchport backup interface command on a port, first enter the
switchport command. For more information, see “Configuring Redundant Links” in
the Layer 2 section in the
Dell Networking OS Configuration Guide.
Interfaces 924