Users Guide

Related
Commands
• interface ManagementEthernet — configure the Management port on the system
(either the Primary or Standby RPM).
• duplex (10/100 Interfaces) — configure duplex mode on physical interfaces with
the speed set to 10/100.
• management route — configure a static route that points to the Management
interface or a forwarding router.
stack-unit portmode
Split a single 40G port into four 10G ports.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member to
reset.
number Enter the port number of the port to be split.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048-ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on
S6000. Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage Information
The port must be in a default configuration before it can be split. As the 40G port is lost
in the configuration when the port is split, ensure that you remove the port from other
L2/L3 feature configurations.
You cannot use this command if you use an LR4 optics.
Interfaces 922