Users Guide

• For ON platforms, you can specify multiple ports as slot/
port/[subport] - slot/port/[subport]. For
example, if you want to display information corresponding
to all ports between 1 and 4, specify the port range as
show interfaces interface-type 1/1/1 - 1/1/4.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.9(0.0) Added support to display the interface configurations
corresponding to a range of ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Output augmented with diagnostic data for pluggable media.
7.7.1.0 Removed three fields in the output: Vendor Name, Vendor OUI,
and Vendor PN.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage Information The following describes the show interfaces transceiver command shown in
the following example.
Line Description
Rx Power
measurement
type
Output depends on the vendor, typically either “Average” or
“OMA” (Receiver optical modulation amplitude).
Interfaces 910