Users Guide

Name: TenGigabitEthernet 1/2
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 1/3
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 1/4
802.1QTagged: True
Vlan membership:
Vlan 2
--More--
Related
Commands
• interface — configure a physical interface on the switch.
• show ip interface — display Layer 3 information about the interfaces.
• show interfaces — display information on a specific physical interface or virtual
interface.
• show interfaces transceiver — display the physical status and operational status of
an installed transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
Syntax
show interfaces interfaces transceiver
Parameters
interfaces
interfaces
(OPTIONAL) Enter one of the following keywords and then the
interface information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
NOTE: This command also enables you to view
information corresponding to a range of ports. However,
for Open Networking (ON) platforms the notation for
specifying port range in the command is different from
how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as
slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces
interface-type 1/1 - 4.
Interfaces 909