Users Guide

Related
Commands
• show interfaces — display information on a specific physical interface or virtual
interface.
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode
interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the
interface information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a backup interface for this interface, enter the keyword
backup.
NOTE: This command also enables you to view
information corresponding to a range of ports.
• For physical interfaces, you can specify multiple ports as
slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces
interface-type 1/1 - 4.
• For port–channel interfaces, you can specify multiple ports
as port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces port—
channel 1 - 4
.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the stack
member number.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Interfaces 907