Users Guide

Current address is 00:01:e8:4c:f2:83
!-------------output truncated ----------------!
Related
Commands
• show hardware stack-unit — display data plane and management plane input/
output statistics.
• show interfaces — display information on a specific physical interface or virtual
interface.
show interfaces status
To display status information on a specific interface only, display a summary of interface information or
specify a stack-unit slot and interface.
Syntax
show interfaces [interface | stack—unit slot-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords the interface
information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
NOTE: This command also enables you to view
information corresponding to a range of ports. However,
for Open Networking (ON) platforms the notation for
specifying port range in the command is different from
how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as
slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/
port/[subport] - slot/port/[subport]. For
example, if you want to display information corresponding
to all ports between 1 and 4, specify the port range as
show interfaces interface-type 1/1/1 - 1/1/4.
stack-unit slot-
number
(OPTIONAL) Enter the keyword stack-unit then the slot
number. The range is from 0 to 5.
Defaults None
Command Modes
• EXEC
Interfaces 905