Users Guide

Version Description
8.3.12.1 Updated command output to support multiple IPv6 addresses
on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.2 Included SFP and SFP+ optics power detail in the E-Series and
C-Series output.
8.2.1.0 Added support for 4093 VLANs on the E-Series. Prior releases
supported 2094.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Output expanded to include SFP+ media on the C-Series.
7.6.1.0 Introduced on the S Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Changed the organization of the display output.
6.3.1.0 Added the Pluggable Media Type field in the E-Series output.
Usage Information
Use the show interfaces command for details on a specific interface.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For
receive/transmit power that is less than 0.000, an snmp query returns the
corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until it
reaches the maximum line rate. When the maximum line rate is reached, there is
no change in the line-rate.
User Information
The following table describes the show interfaces command shown in the 10G
example.
Line Description
TenGigabitEthern
et 1/1...
Interface type and administrative and line protocol status.
Hardware is... Interface hardware information, assigned MAC address, and
current address.
Pluggable media
present...
Present pluggable media wavelength, type, and rate. The error
scenarios are:
• Wavelength, Non-qualified — Dell ID is not present, but
wavelength information is available from XFP or SFP serial
data
Interfaces 892