Users Guide

intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with
autonegotiation disabled, use the no intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Not configured
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can configure the interface type as CR4 with auto-negotiation enabled. If a DAC
cable link is down, you can resolve the issue by setting the interface type as CR4.
Auto-negotiation is disabled by default. If the CR4 optic fails to come up, use the
autoneg option.
Related
Commands
• Interfaces — configure a physical interface.
• interface loopback — configure a loopback interface.
• interface null — configure a null interface.
• interface port-channel — configure a port channel group.
Interfaces 877