Users Guide

Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config
command cannot be used with the bulk configuration feature of the
interface range command. You cannot create virtual interfaces (VLAN, Port-
channel) using the
interface range command.
NOTE: If a range has VLAN, physical and port-channel interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN and port-channel only those respective interfaces
should be configured in a particular range.
Example (Single
Range)
This example shows a single range bulk configuration.
Dell(config)# interface range tengigabitethernet 5/3 - 5/23
Dell(config-if-range-te-5/3-5/23)# no shutdown
Dell(config-if-range-te-5/3-5/23)#
Example (Multiple
Range)
This example shows how to use commas to add different interface types to a range of
interfaces.
Dell(config-if)# interface range tengigabitethernet 5/1 - 5/23,
tengigabitethernet 1/1 - 1/2
Dell(config-if-range-te-1/1-1/2,te-5/1-5/23)# no shutdown
Dell(config-if-range-te-1/1-1/2,te-5/1-5/23)#
Example (Multiple
Range)
This example shows how to use commas to add VLAN and port-channel interfaces to
the range.
Dell(config-if)# interface range tengigabitethernet 5/1 - 1/23,
tengigabitethernet 1/1 – 1/2,
Vlan 2–100, Port 1–25
Dell(config-if-range-te-1/1-1/2,te-5/1-5/23,vl-2-100,po-1-25)# no
shutdown
Dell(config-if-range)#
Related
Commands
• interface port-channel — configure a port channel group.
• interface vlan — configure a VLAN interface.
• show config (from INTERFACE RANGE mode) — display the bulk configuration
interfaces.
• show range — display the bulk configuration ranges.
• interface range macro (define) — define a macro for an interface-range.
interface range macro (define)
Defines a macro for an interface range and then saves the macro in the running configuration.
Syntax
define interface range macro name interface , interface , ...
Parameters
name Enter up to 16 characters for the macro name.
Interfaces 872