Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage Information
The interface group command will create all the non-existent VLANs specified in
the range. On successful command execution, the CLI switches to the interface group
context.
The configuration commands inside the group context will be the similar to that of the
existing range command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and
physical interfaces.
Example
Dell(conf)# interface group ?
fortyGigE FortyGigabit Ethernet interface
gigabitethernet GigabitEthernet interface IEEE 802.3z
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN keyword
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet 1/10
Dell(conf-if-group-vl-1-2,te-1/10)# no shutdown
Dell(conf-if-group-vl-1-2,te-1/10)# end
Related
Commands
• interface range — configure a range of interfaces.
• interface vlan — configures a VLAN.
interface loopback
Configure a Loopback interface.
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Parameters
number Enter a number as the interface number. The range is from 0 to
16383.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Interfaces 866