Users Guide

interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set of
configurations on a group of interfaces.
Syntax
interface group [interface | vlan vlanid {- vlanid } ]
To delete a range of VLANs, use the following command:
no interface group vlan vlanid {- vlanid}
Parameters
interface,
interface,...
Enter the keywords interface group and one of the
interfaces — slot/port or VLAN number. Select the range of
interfaces for bulk configuration. Spaces are not required
between the commas. Comma-separated ranges can include
VLANs and physical interfaces.
Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a single
VLAN ID, or a combination. For example: VLAN IDs (comma-
separated): 3, 4, 6. Range (hyphen-separated): 5-10.
Slot/Port information need not contain a space before and after
the dash. For example, both of the following commands are
valid: interface group tengigabitethernet 1/1 -
1/5; interface group tengigabitethernet 1/1-1/5.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Interfaces 865