Users Guide

on on on on
on on on on
Related
Commands
• show running-config — display the flow configuration parameters (non-default
values only).
• show interfaces — display the negotiated flow control parameters.
interface
Configure a physical or virtual interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and the interface
information:
• For a null interface, enter the keyword null then the slot/
port information. The Null interface number is 0.
• For the Management interface on the stack-unit, enter the
keyword ManagementEthernet then the slot/port
information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the
tunnel ID. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a port channel interface, enter the keywords port-
channel then a number.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Interfaces 863