Users Guide

To delete a description, use the no description command.
Parameters
desc_text Enter a text string up to 240 characters long.
Defaults None
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Modified for E-Series: Revised from 78 to 240 characters.
Usage Information
Important Points to Remember:
• To use special characters as a part of the description string, you must enclose the
whole string in double quotes.
• Spaces between characters are not preserved after entering this command unless
you enclose the entire description in quotation marks (“desc_text”).
• Entering a text string after the description command overwrites any previous
text string that you previously configured as the description.
• The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port-channel.
• Use the show interfaces description command to display descriptions
configured for each interface.
Interfaces 858