Users Guide

to all ports between 1 and 4, specify the port range as
show interfaces interface-type 1/1/1 - 1/1/4.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.9(0.0) Introduced on the S4810, S4820T, S3048-ON, S4048-ON,
S5000, S6000, S6000–ON, and Z9500.
Usage Information
Use the default interface command to set a Gigabit Ethernet, 10- Gigabit
Ethernet, or 40-Gigabit Ethernet interface to its factory-default state. By default, a
physical interface is disabled (shutdown) with no assigned IP address or switchport (no
ip address). This command removes all software settings and all L3, VLAN, VXLAN, and
port-channel configurations on a physical interface.
Example
Dell(conf-if-te-1/5)# show config
!
interface TenGigabitEthernet 1/5
description testconfig
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
Dell(conf-if-te-1/5)#
Dell(conf)# default interface tengigabitethernet 1/5
Dell(conf-if-te-1/5)# show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
Related
Commands
• show running-config – display the current configuration.
description
Assign a descriptive text string to the interface.
Syntax
description desc_text
Interfaces 857