Users Guide

• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield
results.
The show ip igmp interface command does not display information
corresponding to the loop-back interfaces.
Example
Dell# show ip igmp interface
TenGigabitEthernet 1/1 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/5 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/6 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/7 is up, line protocol is down
Internet protocol processing disabled
Internet Group Management Protocol (IGMP) 835