Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Maximum range of the Hello interval value is changed to 18000.
Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
E-Series legacy
command.
Usage Information If you have configured the hello interval value to be greater than 18000, you must first
reset that value to be less than or equal to 18000 before upload. Otherwise, the
command execution fails during bootup and the hello interval value is set to the default
value.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
NOTE: The IGMP query-max-resp-time value must be less than the IGMP query-interval value.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
Parameters
seconds Enter the number of seconds for the maximum response time.
The range is from 1 to 25. The default is 10 seconds.
Internet Group Management Protocol (IGMP) 828