Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on E-Series.
Usage Information The access list accepted is an extended ACL. To block IGMP reports from hosts, on a
per-interface basis based on the group address and source address that you specify in
the access list, use this feature.
ip igmp immediate-leave
Enable IGMP immediate leave.
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-leave
command.
Parameters
group-list prefix-
list-name
Enter the keywords group-list then a string up to 16
characters long of the prefix-list-name.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
Internet Group Management Protocol (IGMP) 825