Users Guide

protocol frrp
Enter the Resilient Ring Protocol and designate a ring identification.
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
ring-id Enter the ring identification number. The range is from 1 to 255.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command places you into the resilient ring protocol. After executing this
command, the command line prompt changes to conf-frrp.
Force10 Resilient Ring Protocol (FRRP) 783