Users Guide

address4] [ip-
address5] [ip-
address6]
NOTE: Use the additional ip-address parameters (ip-
address2 to ip-address6) in a sequential order to
specify up to a maximum of six IP addresses per VRF.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information
Use this command to associate the system with one or more DNS servers.
Example
• Dell(conf)#ip name-server vrf jay 2.2.2.2
• Dell(conf)#ip name-server vrf jay 2.2.2.2 3.3.3.3 4.4.4.4
5.5.5.5 6.6.6.6 7.7.7.7
ip domain-name
Configures the default domain corresponding to a specific VRF. This domain is appended to the in complete
DNS requests corresponding to the specified VRF.
Syntax
ip domain-name [vrf vrf-name] name
To undo the domain name configuration corresponding to a specific VRF, use the no
ip domain-name [vrf vrf-name] name command.
Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the VRF
to configure the domain corresponding to that VRF.
Dynamic Host Configuration Protocol (DHCP) 730