Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added the nfsmount:<mount-
point> parameters that allow you to mount a remote NFS file
system.
9.4(0.0) Added the compressed-config parameter.
9.3(0.1) Added the http parameter on the S6000, Z9000, S4810, and
S4820T.
9.0.2.0 Introduced on the S6000.
8.4.1.0 Added IPv6 addressing support for FTP, TFTP, and SCP.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added usbflash and rpm0usbflash commands on E-Series.
7.6.1.0 Introduced on the S-Series and added the SSH port number to
the SCP prompt sequence on all systems.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information Dell Networking OS supports a maximum of 100 files at the root directory level on both
the internal and external flash.
When copying a file to a remote location (for example, using Secure Copy [SCP]), enter
only the keywords and Dell Networking OS prompts you for the rest of the information.
For example, when using SCP, you can enter copy running-config scp: where
running-config is the source and the target is specified in the ensuing prompts. Dell
Networking OS prompts you to enter any required information for the named
destination — remote destination, destination filename, user ID, password, and so forth.
When you use the copy running-config startup-config command to copy the
running configuration (the startup configuration file amended by any configuration
changes made since the system was started) to the startup configuration file, Dell
Networking OS creates a backup file on the internal flash of the startup configuration.
File Management 71