Users Guide

To return to the default boot sequence, use the no boot system command.
Parameters
gateway Enter the IP address of the default next-hop gateway for the
management subnet.
ip-address Enter an IP address in dotted decimal format.
stack-unit Enter the keywords stack-unit to specify the stack unit
number.
all Enter the keyword all for all the stack units.
stack-unit-
number
Enter the stack-unit number. The range is from 1 to 6.
default Enter the keyword default to specify the default Dell
Networking OS image.
primary Enter the keyword primary to specify the primary Dell
Networking OS image.
secondary Enter the keyword secondary to specify the secondary Dell
Networking OS image.
system: Enter the keyword system: to use the system image file URL
(system).
ftp: Enter the keyword FTP: to retrieve the image from an FTP
server. ftp://userid:password@hostip/filepath.
nfsmount Enter the keyword nfsmount: to retrieve the image from a
mounted NFS file system. nfsmount://filepath
system: Enter the keyword system: to retrieve the image from the
system.
usbflash Enter the keyword usbflash: to retrieve the image from the
USB flash memory. usbflash://filename.
tftp: Enter the keyword TFTP: to retrieve the image from a TFTP
server. tftp://hostip/filepath.
A: | B: Enter A: or B: to boot one of the system partitions.
bmp-boot Enter the keywords bmp-boot to boot the system from the
image present in the DHCP offer.
NOTE: In normal-reload, this keyword is not enabled.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
File Management 67