Users Guide

Version Description
7.7.1.0 Introduced on the S-Series.
Usage Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the off-line diagnostics complete. This reboot is an
automatic process. A warning message appears when the offline stack-unit
command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot
after completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
Syntax
clear hardware stack-unit id {counters | cpu {data-plane
statistics | i2c statistics | management statistics | party-bus
statistics | sata-interface statistics} | unit number counters |
stack-port stack-port-number}
Parameters
stack-unit id Enter the keywords stack-unit then a number to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data. The
range is from 1 to 6.
counters Enter the keyword counters to clear the counters on the
selected stack member.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear
the data plane statistics.
cpu i2c statistics Enter the keywords cpu i2c statistics to clear the i2c
devices statistics.
cpu party-bus
statistics
Enter the keywords cpu party-bus statistics to clear the
management statistics.
cpu sata-interface
statistics
Enter the keywords cpu sata-interface statistics to
clear the sata interface statistics.
Debugging and Diagnostics 662