Users Guide

2 Enter the ip trace-list command, and the name of the Trace list. The prompt changes to include
conf-trace-acl.
You can exit this mode by using the exit command.
VLT DOMAIN Mode
To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, see
Virtual Link Trunking (VLT).
To enter VLT DOMAIN mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the vlt domain command, and then the VLT domain number. The prompt changes to include
conf-vlt-domain.
You can return to CONFIGURATION mode by entering the exit command.
VRRP Mode
To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information,
see Virtual Router Redundancy Protocol (VRRP).
To enter VRRP mode:
1 To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2 Enter the vrrp-group command, and then enter the VRRP group ID. The prompt changes to include
conf-if-interface-type-slot/port-vrid-vrrp-group-id.
CLI Basics 65