Users Guide

Parameters
map-name Displays the PFC and ETS parameters configured in the specified
map.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
9.3(0.0) Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
Usage Information
Use the show qos dcb-map command to display the enhanced transmission selection
(ETS) and priority-based flow control (PFC) parameters used to configure server-facing
Ethernet ports. S5000 Ethernet ports are DCBx-enabled by default.
The following table describes the show qos dcb-map output shown in the example
below.
Field Description
State Complete: All mandatory DCB parameters are correctly
configured. In progress: The DCB map configuration is not
complete. Some mandatory parameters are not configured.
PFC Mode PFC configuration in DCB map: On (enabled) or Off.
PG Priority group configured in the DCB map.
TSA Transmission scheduling algorithm used by the priority group:
Enhanced Transmission Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or Off.
Priorities 802.1p priorities configured in the priority group.
Example
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Data Center Bridging (DCB) 641