Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.3(0.0) Introduced on the S4810, S6000 platforms.
Usage Information
PFC and ETS settings are not pre-configured on Ethernet ports. You must use the dcb-
map command to configure different groups of 802.1p priorities with PFC and ETS
settings.
Using the priority-pgid command, you assign each 802.1p priority to one priority
group. A priority group consists of 802.1p priority values that are grouped together for
similar bandwidth allocation and scheduling, and that share latency and loss
requirements. All 802.1p priorities mapped to the same queue must be in the same
priority group. For example, the
priority-pgid 0 0 0 1 2 4 4 4 command
creates the following groups of 802.1p priority traffic:
• Priority group 0 contains traffic with dot1p priorities 0, 1, and 2.
• Priority group 1 contains traffic with dot1p priority 3.
• Priority group 2 contains traffic with dot1p priority 4.
• Priority group 4 contains traffic with dot1p priority 5, 6, and 7.
To remove a priority-pgid configuration from a DCB map, enter the no priority-
pgid command.
For PFC enabled priorities, it is recommended to map single priority per Priority group.
pfc mode on
Enable the PFC configuration on the port so that the priorities are included in DCBX negotiation with peer
PFC devices.
Syntax
pfc mode on
To disable the PFC configuration, use the no pfc mode on command.
Defaults PFC mode is on.
Command Modes DCB MAP
Data Center Bridging (DCB) 637