Users Guide

0 Pause Tx pkts, 0 Pause Rx pkts
Dell#
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
NOTE: Before configuring ETS, assign the etsacl space. using the cam-acl l2acl 2 ipv4acl 0
ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1
iscsi 2 command.
bandwidth-percentage
Configure the bandwidth percentage allocated to priority traffic in port queues.
Syntax
bandwidth-percentage percentage
To remove the configured bandwidth percentage, use the no bandwidth-
percentage command.
Parameters
percentage (Optional) Enter the bandwidth percentage. The percentage
range is from 1 to 100% in units of 1%.
Defaults none
Command Modes QOS-POLICY-OUT-ETS
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
By default, equal bandwidth is assigned to each port queue and each dot1p priority in a
priority group. To configure bandwidth amounts in associated dot1p queues, use the
bandwidth-percentage command. When specified bandwidth is assigned to some
Data Center Bridging (DCB) 612