Users Guide

show interface pfc statistics
Displays counters for the PFC frames received and transmitted (by dot1p priority class) on an interface.
Syntax
show interface port-type pfc statistics
Parameters
port-type Enter the port type and the interface information.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation for
specifying port range in the command is different from how you specify in non-
ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-
range. For example, if you want to display information corresponding to all
ports between 1 and 4, specify the port range as
show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/
[subport] - slot/port/[subport]. For example, if you want to
display information corresponding to all ports between 1 and 4, specify the
port range as show interfaces interface-type 1/1/1 - 1/1/4.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Enabled to display the command output even without enabling
DCB.
9.9(0.0) Added support to display the interface configurations
corresponding to a range of ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB) 610