Users Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Specify a stack-unit number on the Master switch in a stack.
Example
Dell# show dcb
stack-unit 1 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
Dell#
show interface pfc
Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
Syntax
show interface port-type slot/port[/subport] pfc {summary |
statistics | detail | buffer-threshold}
Parameters
port-type slot/
port[/subport] pfc
Enter the port-type slot and port PFC information. Enter the
subport number if a 40G port is fanned-out into 10G ports.
{summary |
statistics | detail |
buffer-threshold}
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results. Enter the
keyword
statistics to view pfc statistics. Use the keyword
buffer-threshold to display the buffer threshold details.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation for
specifying port range in the command is different from how you specify in non-
ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1
and 4, specify the port range as show interfaces interface-type 1/1 -
4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] -
slot/port/[subport]. For example, if you want to display information
Data Center Bridging (DCB) 606