Users Guide

Prompt Interface Type
Dell(conf-if-
ma-1/1)#
Management Ethernet interface then slot/port information
Dell(conf-if-
tu-0)#
Tunnel interface then tunnel ID.
Dell(conf-if-
range)#
Designated interface range (used for bulk configuration).
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the
ip access-list standard command or the ip access-list extended command.
To enter IP ACCESS LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter either the ip access-list standard command or the ip access-list extended
command. Include a name for the ACL. The prompt changes to include conf-std-nacl or conf-ext-
nacl
.
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see
Intermediate System to Intermediate System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
1 Verify that you are logged in to ROUTER ISIS mode.
2 Enter the address-family ipv6 unicast command. The prompt changes to include conf-
router_isis-af_ipv6.
LLDP Mode
To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, see
Link Layer Discovery Protocol (LLDP).
To enter LLDP mode:
1 To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an
interface, verify that you are logged in to INTERFACE mode.
2 Enter the protocol lldp command. The prompt changes to include conf-lldp or conf-if-
interface-lldp.
CLI Basics 59