Users Guide

Parameters
policy-map name Enter the name of the policy-map to verify. Maximum is 32
characters.
number Enter all to get information for all the stack-units or enter the
stack-unit number to get information for a specific stack-unit.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced.
Usage Information
This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when
verifying QoS optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy
on a single (or the first of several) interfaces. It is most useful when a policy is applied
across multiple interfaces; it can reduce the impact to CAM usage across subsequent
interfaces.
The following describes the test cam-usage command shown in the following
example.
Term Explanation
Stack-Unit
Lists the stack unit or units that are checked. Entering all shows
the status for all stacks.
Content Addressable Memory (CAM) 589